Accessories & Options; Installation Of Accessories; Antenna Installation; Belt Clip Installation - Yaesu VX-5R Operating Manual

Accessori es & Options
ACCESSORIES SUPPLIED
WITH THE VX-5R
FNB-58LI
Battery Pack (7
.2V/1100mAh)
NC-72B/C/F/U
Battery Chareger
Belt Clip
Hand Strap
Antenna
Operating Manual
Warranty Card
AVAILABLE OPTIONS
FOR YOUR VX-SR
1 0 CSC-73
Soft Case
CD-15
Rapid Charger
(requires
NC-72B/C/F/U)
03
FBA-23
2 x "AA" Cell
Battery Case
(batteries not supplied) 40
FNB-58LI
Battery Pack
E-DC-5B
DC Cable w/Nois`e Filter
NC-72B/C/F/U
Battery Ch
O E-DC-6
® CT-44
OO MH-37A4B
1
o MH-34B4B
11
VC-25
12
CN-3
13
SU-1
14
CT-27
ger
DC Cable ; plug and
wire only
Microphone Adapter
Earpiece/Microphon e
Speaker/Microphone
VOX Headset
BNC-to-SMA Adapter
Barometric Pressure
Sensor Unit
Cloning Cable
Availability of accessories
may vary. Some
accessories are supplied
as standard per
local
requirements, while
others may be
unavailable in some regions
. Consult
your Yaesu Dealer
for
details regarding these
and any newly-available
options . Connection
of any
non-Yaesu-ap-
proved accessory,
should it cause damage,
may void the Limited
Warranty on this
apparatus .f 6
VX-SR OPERATING
MANUAL
The supplied
antenna provides good results
over the entire frequency range of
the trans-
ceiver. However,
for enhanced base station medium-wave
and shortwave reception, you
may wish to
connect an external (outside)
antenna .
The supplied
antenna includes a "Base" and an "Extender
Element ." The Extender Ele-
ment should be used
below 54 MHz, and its installation
will still allow satisfactory 144;
430 MHz operation .
To install the supplied antenna
Hold the bottom end of the
antenna, then screw it onto the mat-
ing connector on the
transceiver until it is snug . Do not over-
tighten by use of extreme
force .
When operating the VX-5R on
frequencies lower than the 50
MHz band, disconnect the
antenna cap from the base antenna
then screw the Extender Element
onto the Base Antenna .
Notes:
O
Never transmit without having an antenna
connected .
O
When installing the supplied antenna,
never hold the upper
part of the antenna while screwing
it onto the mating con-
nector on the transceiver .
O
If using an external antenna
for transmission, ensure that
the SWR presented to the transceiver
is 1 .5 :1 or lower.
O
Take care not lose the antenna cap
when removing it from
the Base Antenna .
To install the Belt Clip, first place the loop of
the Hand Strap into the groove at the
top of
the Belt Clip, and run the loop of the strap
around the round mounting ridge for
the Belt
Clip . Now insert the mounting screw
through the belt clip, and affix it snugly
to the mount-
ing hole on the back of the transceiver,
being careful not to allow the Hand Strap to
become
mis-aligned .
Do not install the supplied Belt Clip
Mounting Screw
if
you are not install-
ing theBelt Clip! Thescrew will cause
a "short circuit" to the internal cir-
cuitry, causing serious damage!
Installation of Accessories
ANTENNA INSTAL LATION
BELT CLIP INST ALLATION