External Dc Power Supply Connection; Antenna Installation; Belt Clip Installation - Yaesu FTA-450L Operating Manual

External DC Power Supply Connection

You may insert the cable plug of the optional SDD-12
Cigarette Lighter DC/DC Converter into the EXT DC
jack located on the right side of the transceiver. In this
case, the " " icon will appear in the top right corner
of the LCD display.
When making DC connections via the SDD-12, be ab-
solutely certain to observe the proper voltage level and
polarity guidelines.
 The SDD-12 can be connected to 12 to 24 Volt DC
power sources.
As close
as possible
 For noise reduction from exogenous noise, wind one
turn of the SDD-12 cable around the ferrite core,
and snap its two halves together, per the illustration
above. Attach the ferrite core as close as possible to
the SDD-12 body, as shown.
FTA-450L O
perATing
B
efore
SDD-12
Cigarette Lighter DC/DC
Converter (12 to 24 Volts)
Ferrite Core
Wind the cable one turn,
then snap two halves
M
AnuAL
y B
ou egIn
Do not connect any accessory unapproved
by YAESU to supply DC power; otherwise
the FTA-450L may be damaged.

Antenna Installation

 To attach the supplied antenna to the FTA-450L,
grasp the base of the antenna
firmly, and exert a moderate
"pinching" pressure on the
base as you press the antenna
onto the radio's antenna con-
nector. While exerting this
pressure, rotate the antenna
clockwise 1/4 turn to lock the
antenna in place.

Belt Clip Installation

D A
T A
You may mount the clip to the rear of the FTA-450L
E X
T
D C
using the supplied screws.
D A
T A
E X
T
D C


SHB-11
Belt Clip
with two screws (M3 x 8)
15