Alkaline Battery Tray Installation; Low Battery Indication - Yaesu FTA-750L Spirit Operating Manual

Alkaline Battery Tray Installation

The supplied SBT-12 Battery Tray allows operation of
the FTA-750L/FTA-550/FTA-450L using six "AA"
size alkaline battery cells.
 When installing a cell, insert the (–) end first, then
press in the (+) end so the cell snaps into place. Pay
attention to the polarity indicated inside the case.
The SBT-12 must not be used with re-
chargeable cells. The SBT-12 does not con-
tain the thermal and over-current protec-
tion circuits required when utilizing Ni-Cd and Ni-
MH cells.
Note: Replace all six cells at the same time in case of
low battery.
16
Before You Begin
SBT-12
Alkaline Battery Tray
 To install the SBT-12, remove the Lithium-ion bat-
tery pack first from the transceiver, turn the open
side of the SBT-12 down, then insert it into the bat-
tery compartment.
Note: Be sure that the rubber gasket on the SBT-12
is not loose when inserting.

Low Battery Indication

As your battery discharges during use, the voltage
will gradually become lower. When the battery volt-
age reaches 6.0 Volts, the "
LCD display, indicating that the battery pack must be
recharged or the alkaline battery cells must be replaced
before further use.
 Avoid recharging Lithium-ion batteries before the
"Low Battery" indicator is observed, as this can de-
grade the charge capacity of your Lithium-ion battery
pack. YAESU recommends that you carry an extra,
fully-charged pack with you so you will not lose
communications capability due to a depleted Lithi-
um-ion battery.
 The fully-charged battery lasts for 12 hours on the
FTA-750L or 13.5 hours on the FTA-550/FTA-
450L under the conditions below:
Battery saver ... OFF
Operation ratio ... TX:RX:Standby = 6:6:48 (sec)
" icon will blink on the