Cleaning The Display Case - Bonnet Neve SKYLIGHT User Instructions

not dissolve in water and consequently does not get stained when soaking wet The antifog film is not damaged by
commercial glass cleaners, stain removers, ammonia, alcohol or benzine and does not undergo discoloring when
exposed to the sunlight or heat.
DOORS ARE PROVIDED WITH AN ANTIFOG FILM LAMINATED ONTO THE INTERNAL SIDE OF THE GLASS, AND
GUARDED BY A PROTECTIVE LAYER. THE SIDES OF THE PROTECTIVE LAYER ARE SLIGHTY LIFTED IN ORDER FOR
THE LAYER TO BE EASILY REMOVED FOR USE. THE PROTECTIVE LAYER MUST BE REMOVED AFTER THE DOORS HAVE
BEEN FITTED ONTO THE CABINET AND ONLY WHEN THE CABINET HAS REACHED OPERATING TEMPERATURE, SO
THAT THE ANTIFOG FILM MAY START TO FUNCTION IMMEDIATELY. This is reminded by the label affixed on the pro-
tective film:" DO NOT REMOVE THE PROTECTIVE FILM UNTIL THE CABINET HAS REACHED THE
OPERATING TEMPERATURE".
Surfaces so treated may be cleaned using common glass cleaner and a sponge, a rag or a paper towel. Do not use
detergent containing abrasive, strongly acidic or caustic substances. Unless removed, greasy residue from cigarettes
or airborne oil may diminish the film's antifog properties. Greasy residue must be removed using oil stain remover.
REFRIGERANT R744
The refrigerant R744 is an environmentally compatible gas. Use great care during transport, installation and disman-
tling to prevent damage to the refrigeration piping.
IN CASE OF DAMAGE: keep the unit away from flames or ignition sources. Ventilate the premises well for a few minu-
tes. Switch the unit off, pull our the power plug. Inform an Authorized Service Centre.
CAUTION: the refrigeration system is High Pressure. Do not tamper with the system and contact a qualified, speciali-
zed technician before disassembly.
CAUTION: maintenance should be carried out only by qualified personnel.
Children should be supervised to ensure they do not play with the unit.

CLEANING THE DISPLAY CASE

1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm water only.
Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents, alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-cleaning
products exclusively. The use of water is not recommended here, as it may cause scale to build up.
CAUTION! NEVER WASH OR CLEAN THE UPPER PART OF THE DISPLAY CASE WITH WATER OR LIQUIDS
2) Every month clean the inside surfaces following the instructions provided in the preceding item:
3) Every three months clean the grates uder the superstructure bottom shelfs (fig. 21).
4) Defrost the display case every three months to let the ice that may have formed between the fins melt. Frost may
otherwise prevent correct operation. Proceed as follows.
· Disconnect the display case from the electrical power supply by the wall main cut-off switch (fig. 19).
· Empty the appliance, store the contents in cold rooms or refrigerators that are adequate for keeping the requisite
preservation temperature.
· Wait until the cold room has reached ambient temperature.
· Clean the inside of the display case thoroughly with mild soap or detergent and lukewarm water. Wipe carefully
with a soft cloth.
· After having carefully checked that the display case is completely dry inside, start the appliance again by the wall
cut-out switch.
· Allow a couple of hours before loading the products back again.
Attention! Disassemble and assemble very slowly, using heavy-duty gloves. It is advisable to have these clea-
ning operations carried out by authorized service personnel.
UM000173
16