Table of Contents
Advertisement
Before You Begin
•
All dimensions are given in inches
(millimeters). DO NOT scale drawings.
•
Thickness recommended for reinforcements
in hollow metal doors and frames is charted.
•
Template information is based on use of 5"
(127mm) maximum width butt hinges or
3/4" (19mm) offset pivots.
•
Maximum frame reveal is 1/8" (3mm) for
PULL units.
•
Before beginning the installation, verify that
the door frame is properly reinforced and is
well anchored in the wall. Frame header must
be straight - without warp or bow.
•
Unreinforced hollow metal frames and
aluminum frames should be prepared and
fitted with 1/4-20 blind rivet nuts, furnished
by others.
•
Concealed electrical conduit and concealed
switch or sensor wires should be pulled to
the frame before proceeding.
Fasteners for Frame:
•
Hollow metal and aluminum: 1/4-20 Machine
screws
•
Wood:
No. 14 x 2-3/4" (70mm) sheet metal screws
Fasteners for Door (Pull Side Mounting):
•
No. 12 x 1-3/4" Sheet Metal screws
4
Mounting Hardware
Unit:
14 x 2-3/4"
Sheet Metal Screw
Unit:
1/4-20 x 1" Flat Head Machine Screw
Track:
12 x 1-3/4" Sheet Metal Screw
Templating based on 1/8" gap
between door and frame.
Hollow Metal Door Frame Reinforcing
Frame Material
Recommended
12 Ga.
.105
(2.66)
14 Ga.
.075
(1.90)
16 Ga.
.060
(1.52)
18 Ga.
.048
(1.21)
Door or Frame
Wood
Hollow Metal or
Aluminum
Wood
Hollow Metal or
Aluminum
Copyright © 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
5500 Series Power Operator
Frame
Door
1/8"
(3)
Reinforcing
Min. Required
12 Ga.
18 Ga.
.105
.048
(2.66)
(1.21)
10 Ga.
12 Ga.
.134
.105
(3.41)
(2.66)
10 Ga.
12 Ga.
.134
.105
(3.41)
(2.66)
8 Ga.
10 Ga.
.164
.134
(4.18)
(3.41)
Drill
3/16" (4.76mm)
Drill #7 (.201 dia. or 5.10mm)
Tap 1/4-20
Drill 3/32" (2.38mm)
Drill #16
Tap 12-24
80-9355-0001-020 Rev 1 08/20
Advertisement
Table of Contents
