Final Electrical And Mechanical Setup - Assa Abloy Norton 5500 Series Installation Instructions Manual

Final Electrical and Mechanical Setup

1. Confirm all mechanical adjustments have been
made and wiring connected.
2. Turn on facility's main circuit breaker.
3. Turn on power of operator at On/Off switch.
(Figure 17)
4. Using a short jumper cable, jump terminals A1
and A2 to activate unit. When door reaches 20°,
flip On/Off Switch to "OFF" position cutting power
to unit. Allow door to fully close (door may be
manually pulled closed).
5. Adjust Closed Position Magnet (Figure 18)
• With door in closed position, use finger to slide
Closed Position Magnet so it aligns directly with
Reed Switch.
6. Adjust Open Position Magnet (Figure 18)
• Use finger to slide Open Position Magnet 180°
from Closed Position Magnet.
7. Flip On/Off Switch to "ON" to turn power on.
8. Jump terminals A1 and A2 to activate door. Note
open position of door. Allow door to close.
9. Use finger to readjust Open Position Magnet to
desired door open position.
10. Repeat Step 7 to verify door open position.
11. Make all connections necessary for any accessories
to A1, A2, R1, and R2 on terminal strip.
See Wiring Section.
12. Make necessary adjustments to inverter.
See Inverter Details Section.
Continue with Electrical Instructions to customize the installation.
10
WARNING: 120VAC power supplied to operator must
be a dedicated circuit from the main circuit breaker
panel and must NOT be connected into any building
lighting system that operates fluorescent lights.
You've now installed the 5500 Operator - PULL SIDE.
On/Off Switch
Figure 17
Figure 18
Copyright © 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
5500 Series Power Operator
120VAC Electrical Connections,
Activation Inputs, Fuse
80-9355-0001-020 Rev 1 08/20