Tertiary Air - Hamlet Solution S4 User Manual

Hamlet Solution Inset (S4) Stove User Guide
USER GUIDE
The control has an internal sliding plate with slots, housed inside the body of the appliance
and is located centrally above the fire door assembly, when looking at the front of the
appliance.
Sliding the control knob to the right, as far as it will go, achieves the fully open position, see
figure 3. Sliding it to the left will shut down / reduce the air as shown in figure 4.
Fig. 3. Fully Open Position
Fig. 4. Fully Open Position
NOTE : If your stove installation is within a smoke control area, it will be fitted with a
restrictor screw, acting as a mechanical stop for the secondary air control. This will not fully
close, thus allowing a bleed of air to the fire box to reduce smoke emissions.

5.1.4 Tertiary Air

All models have tertiary air supply that can be seen working during certain conditions during
the burning period. The outlet for the tertiary air, is at the rear of the fire box chamber, just
below the throat plate through a series of small holes. (See page 6).
Tertiary air is employed, to provide additional air to the upper areas of the fire box to
promote additional burning of the unburnt combustion gases and thus ensuring a cleaner
burn emission.
The 7kW version has no user adjustment required for the tertiary air, as the required air
supply is factory set during the production process.
BK745 Page 13