Warning - Fume / Smoke Emissions; Refuelling On To A Low Fire Bed - Hamlet Solution S4 User Manual

6.4 Warning - Fume / Smoke emissions

Properly installed, with a suitable flue or chimney, operated and maintained correctly, this
appliance will not emit fumes into the dwelling. Occasional fumes when de-ashing and
refuelling may occur. However, persistent fume emission is potentially dangerous and must
be investigated by an approved / registered installer.
STOP USING THE APPLIANCE IF YOU SMELL FUMES OR SEE
If fume emission does persist, the following immediate actions should be taken:
• Open doors and windows to ventilate room.
• Let the fire die or extinguish and safely dispose of fuel from the appliance.
• Check for flue or chimney blockage, and clean if required.
Seek expert advice from your approved installer.
Do not attempt to re-light the fire until the cause of the fume emission has been identified
and corrected.

6.5 Refuelling on to a low fire bed

If there is insufficient burning material in the fire bed to light a new fuel charge, excessive
smoke emission can occur. Refuelling must be carried out onto a sufficient quantity of
glowing embers and ash that the new fuel charge will ignite in a reasonable period. If there
are too few embers in the fire bed, add suitable kindling for ignition to prevent excessive
smoke.
Important notes on usage, to meet the requirements of Smoke Control exemption -
Always recharge onto hot embers.

After re-charging, fully open both the primary and secondary air controls for the

following times, in order to establish good combustion -
Hamlet Solution 5kW Inset S4—2 to 3 minutes with the fire door ajar
Hamlet Solution 7kW Inset S4 — 3 minutes with the fire door ajar
Do not leave the appliance unattended until flames are well established.

Periodic burning out of the fuel bed at high output to combust any remaining

charcoal.
BK745
SMOKE ESCAPING.
Hamlet Solution Inset (S4) Stove User Guide
USER GUIDE
Page 17