Warp Settings, Moving Cursors; Warp Settings,Test Pattern - Barco G60 W Series User Manual

Warp and blend tool

Table of Contents

Using the Warping and Blending tool

3.5 Warp settings, Moving Cursors

Overview

Move the cursors on the projection screen to perform warping.

•

Select cursor. To select a cursor, click the cursor or use "W", "A", "S", and "D" on the keyboard.

The selected cursor will change to blue.

•

Move cursor. Use arrow keys on the keyboard to move the selected cursor.

•

Adjust cursor

Start with a minimal number of grids and gradually increase the number of grids. It is advisable to

starting with 2 x 2 setup.

Using fewer grid number allows for easier warping control.

As shown below, adjust the outer cursors in red first, and then adjust the inner cursors in green.

Image 3-6

If starting with larger grid number, all the warping settings will be lost when decreasing the grid

number.

Overview

Test pattern helps to tune the edge blending. When performing edge blending, test pattern helps to align the

two projection screen as shown in the example below.

•

Enabling the test pattern to assist in tuning the edge blending.

R5910890 /01

G60 W series

Table of Contents