Using the Warping and Blending tool
Reset
Reset all settings for edge blending (6).
3.8 Edge Blending, Enable Marker
Overview
Using markers to highlight the blending areas helps with the edge blending process. As shown below, red and
green lines were used to mark the overlapping area.
•
Enabling markers to highlight the blending areas for the two projection screens.
Image 3-10
•
The overlapping area is adjusted using the markers.
Image 3-11
3.9 Black Level
Start up
Click on Black Level tab to adjust the back level of the projection screens to achieve better black uniformity.
28
R5910890 /01
G60 W series