139 x 160 x 248 mm Weight 2.3kg Ink ribbon cartridge KERN YKG-A03 (Option) 2 Unpacking Remove device and accessories carefully from packaging, remove packaging material and place device at the planned work place. Check if that there has been no damage and that all packing items are present.
Does not light up when the printer is operating properly. Flashes when an error occurs. (See "Troubleshooting" section.) Paper out Indicates that the paper is finished. FEED Paper forward feed button YKG-01-BA-e-1910...
4 Basic instructions Carefully read this operation manual before setup and commissioning, even if you are already familiar with KERN products. All language versions contain a non-binding translation. The original German is binding. 4.1 Safety instructions / warning signs ...
Our conditions in the operation manual are ignored The appliance is modified or opened Mechanical damage or damage by media, liquids, natural wear and tear The appliance is improperly set up or incorrectly electrically connected YKG-01-BA-e-1910...
4.4 Mains connection Do not connect the appliance to the power mains unless the information on the appliance (sticker) matches the local mains voltage. Only use KERN original mains adapters. Using other makes requires WARNING consent by KERN. Important: ...
Note: CAUTION Use the following ink ribbon cartridge in your printer: KERN YKG-A03. 1. Open the ink ribbon cartridge cover using the tabs on the side as shown in Figure D. 2. Turn the knob two or three times in the direction of the arrow as shown in Figure E to increase the tension in the ink ribbon slightly.
Page 10
CAUTION injuries cannot be ruled out. When replacing the ink ribbon cartridge, first lift the left side of the ink ribbon cartridge, than lift the entire ink ribbon cartridge. YKG-01-BA-e-1910...
CAUTION 1. Cut the front end of the paper roll as described in Figure G shown using scissors. 2. Turn on the printer and open the paper roll cover using the tab. YKG-01-BA-e-1910...
Page 12
See figure G-a. 4. If you are not using a paper take-up reel, pull out a short piece of paper and close the paper roll cover; then tear off the paper using the manual paper cutter. YKG-01-BA-e-1910...
Page 13
DO NOT open the paper roll cover during printing or while paper is being fed through. When using the printer, do not forget to tear off the paper using the manual cutter after the paper has been fed through. YKG-01-BA-e-1910...
1. Open the paper roll cover using the tab as shown in Figure H. 2. Remove what is left of the paper roll. 3. Insert a new paper roll. See section "Inserting the paper roll" (chapter 5.3). YKG-01-BA-e-1910...
Mains cable Cash box drawer When using a serial interface, error-free operation is only ensured with the enclosed interface cable and the corresponding KERN interface cable (option). CAUTION If necessary, use the zero modem supplied and a gender changer.
Make sure the printer is turned off and wipe any dirt off the printer housing with a dry or damp cloth. Never clean the product with alcohol, petrol, thinner, or other solvents. Plastic or rubber parts may be damaged or broken by these. CAUTION YKG-01-BA-e-1910...
Allow it to cool down before reaching into the printer. Open the paper roll cover using the tab as shown in Figure H and clear the paper jam. Reinsert the paper roll and close the paper roll cover. YKG-01-BA-e-1910...
Need help?
Do you have a question about the YKG-01 and is the answer not in the manual?
Questions and answers