Auto-Set Function - Immergas VICTRIX PRO 35 1 I Instruction For Technician And Installer

NOTE: The code is supplied on request by the
IMMERGAS technical service.
If the code is correct the words "INSTALLER
OK" appear on the display. In case of error the
write "CODE ERROR" is visualized.
INSTALLEr C O D E E R R o r
OK
Attention: if any operation is executed for ten
minutes the code must be re-
entered.
After the code is entered, all the parameters
reported in the tables from page 24 to page 35
can be modified.
The following menus are available in addition
to the ones listed in the "user" section of this
manual:
- HyDRAULIC: for the settings related to the
system realized;
- HEAT GENERATOR: to set the kind of boi-
ler;
- SOLAR: to regulate the settings of a possible-
solar panel;
- CASCADE: to regulate the settings for the
cascade functioning;
- BUFFER: to regulate the settings of a possible
storage buffer;
- BUS: to set the BUS address;
- RELAy TEST: to activate the relays of the
regulator manually;
- ALARm: to visualize the anomalies of the
functioning;
- SENSOR ADJUSTmENT: to modify the
temperatures values of the sensors.

AUTO-SET function.

Thanks to this function, it is possible to set auto-
matically the presence of heating and domestic
hot water circuits wich sensors are connected to
the regulator.
The AUTO - SET is activated after the switch on
of the appliance and it works for the following
24 hours.
If during the first start-up, a configuration is re-
gistered, its change is possible only if the AUTO
- SET function is activated. This activation can
carry out cutting off the power supply and to
restore it pressing the knob.
Page 12