Palazzetti Inserimento A70 Installation, User And Maintenance Manual page 34

5. Unscrew the six locking bolts of the guides
positioned on the bottom of the machine and
remove the right side strip (Fig. 6.1.4).
6. Disconnect the display cable connector, with
its relative mass, from the board and the power
cable.
7. Temporarily disassemble the cardholder
assembly (A) using the two screws (B) and
place it carefully on the stationary base of the
machine (Fig. 6.1.4A).
8. Cut the cable ties that group the cables and
prevent the machine from being pulled out.
9. Take care not to damage the wiring or electronic
parts during handling.
10. Lift the machine and remove it from the guides
(Fig. 6.1.5);
11. Remove the pallet fixing screws from the base
and remove the pallet (Fig. 6.1.6).
12. Rest the base on the floor of the chimney (1),
trace and make 4 holes (diameter 6) for fixing
(2) - use the base itself as a template - then drill
the holes with a bit with a diameter of 6 mm
(Fig. 6.1.7A)
13. Insert the 6mm screw plugs in the holes and
fix the base with the screws. (3) - (Fig. 6.1.7B)
1
Fig. 6.1.7A
34
INSTALLATION
Fig. 6.1.5
2
Ø 6mm x 6
00 4776070 - 17/12/2018 - PN - Italy
1
Fig. 6.1.7B
Fig. 6.1.4
Fig. 6.1.4A
A
B
Fig. 6.1.6
3
Ø 6mm x 6