Start-Up; Operation - AL-KO Solo 7505 VR Instructions For Use Manual

GB
1. Remove the lateral protective discs (10/1)
from the tiller blade shaft (10/2).
2. Place the tiller blade shaft (10/3) of the wide
tiller set onto the already mounted tiller blade
shaft (10/2) in such way that the edge of the
tiller blades points towards the front side of
the cultivator.
3. Push both tiller blade shafts into each other,
turning both tiller blade shafts in such a way
that the holes of the two shafts coincide.
4. Push the split safety pin (10/4) through the ho-
les of the tiller blade shafts and secure against
sliding out again with the safety locking me-
chanism (10/5). The safety locking mecha-
nism must be rotated in rotation direction A,
exactly as displayed in the figure (10).
CAUTION!
Risk of injury due to detaching
machine parts!
If the safety locking mechanism ro-
tates counter to the direction of ro-
tation, the wide tiller set can detach
if the cultivator is running and injure
people.
Insert the safety locking mecha-
nism in the direction of rotation.
5. Replace the lateral protective discs (10/1) and
attach them with the screw (10/6) and the nut
(10/7).
Mounting the guard plate extension:
1. Place the guard plate extension (11/1) on the
already available guard plate (11/2) as shown
in the figure (11).
2. Attach the guard plate extension to the exis-
ting guard plate with the screws (11/3).
22

START-UP

Adjusting Bowden cables
See chapter "Maintenance and care".
Adjusting the height of the handlebar (6)
The height of the handlebar depends on your
body height. The handlebar should be at waist
height.
1. Turn both grips (06/5) for the height adjust-
ment of the handlebar open until the handle-
bar can be pressed down or up.
2. Press the handlebar down or up until it is at
the required height.
3. Retighten both grips for the height adjust-
ment.

OPERATION

Fuel fill
See operating instructions of the motor.
Roll the cultivator to the place where it is to
be used (12)
The cultivator is easy to roll to the place of opera-
tion using the transport wheel (12/1).
1. If the transport wheel is folded in: Pull out (di-
rection A) the transport wheel (12/1) on the
wheel mount (12/2). Fold it down into the drive
position and release it so it can lock in place.
2. Lift the cultivator using the handlebar until it is
on the transport wheel (12/1).
3. Push the cultivator to the place of operation.
4. Folding in the transport wheel for tilling: Pull
out (direction A) the transport wheel (12/1) on
the wheel mount (12/2). Fold it upwards into
the horizontal position and release it so it can
lock in place.
Starting and stopping the motor (14)
Starting the motor:
1. Open the petrol cock by pushing the lever
(14/1) in the ON arrow direction.
2. If the motor is cold:
Push the choke lever (14/2) towards the
choke symbol. Only use this position for star-
ting the motor.
Start-up
7505 VR / 7505 V2R