Storage - AL-KO Solo 7505 VR Instructions For Use Manual

Maintenance and care
Replacing the air filter and spark plug
See operating instructions of the motor.
Readjusting the Bowden cable of the gas
lever
See operating instructions of the motor.
Readjust the Bowden cables for the clutch
lever and reverse gear (only 7505 VR) (21)
The fine adjustment of a Bowden cable is carried
out with the respective setscrew on the Bowden
cable ends. One setscrew is on the lever on the
handlebar and the other at the attachment point
of the motor clutch or at the attachment point of
the motor gearbox.
The travel of the Bowden cable for the tiller blades
must be set in such a way that the tiller blades
start to turn after the clutch lever (21/1) has travel-
led halfway. If the clutch lever (21/1) or the lever
(21/7) for the reverse gear has been completely
pressed on the handlebar, the associated tension
spring (21/2) must be pulled apart by 8-10 mm.
1. Loosen the locknut of the setscrew on the re-
spective Bowden cable. For the clutch lever:
(21/3) and (21/4). For the lever of the reverse
gear: (21/5) and (21/6).
2. Turn the setscrew to lengthen or shorten the
travel of the Bowden cable.
3. Tighten the locknut again.

STORAGE

WARNING!
Danger of fire - Danger of serious da-
mage to people and property.
Persons can be seriously injured due to
exploding fuel vapours and serious da-
mage to property can occur.
Only store the fuelled appliance in a
well-ventilated area.
Do not store the fuelled appliance
in buildings where fuel vapours can
come into contact with open flames
or sparks.
441582_ 25