Toyota Land Cruiser Prado 2012 Manual page 406

2-5. Driving information
 When connecting and disconnecting a trailer (vehicles with rear height
control air suspension)
 Connecting
STEP 1 Set the rear height control air suspension to LO mode.
STEP 2 Turn off the "ENGINE START STOP" switch or the rear height con-
trol air suspension.
STEP 3 Connect the trailer.
STEP 4 Turn on the switch that was turned off on step 2.
STEP 5 Set the rear height control air suspension to N mode.
 Disconnecting
STEP 1 Set the rear height control air suspension to LO mode.
STEP 2 Turn off the rear height control air suspension.
STEP 3 Turn off the "ENGINE START STOP" switch.
STEP 4 Set the supporting leg of a trailer on the ground and raise the hitch
by 100 mm (4 in.).
STEP 5 Turn on the "ENGINE START STOP" switch.
STEP 6 Turn on the rear height control air suspension.
STEP 7 Wait until vehicle height is stabilized.
Make sure the hitch is disconnected. If the hitch does not disconnect, raise
the hitch higher and repeat steps 2 through 7.
406
L/C150_OM_OM60J78E_(EE)