Toyota Land Cruiser Prado 2012 Manual page 139

When the power window does not close normally

If the jam protection function is operating abnormally and a window cannot
be closed, perform the following operations using the power window switch
on the relevant door.
After stopping the vehicle, the window can be closed by holding the

power window switch in the one-touch closing position while the engine
switch is in the "ON" position. (vehicles without a smart entry & start sys-
tem), the "ENGINE START STOP" switch is turned to IGNITION ON
mode (vehicles with a smart entry & start system).
 If the window still cannot be closed even by carrying out the operation
explained above, initialize the function by performing the following proce-
dure.
Hold the power window switch in the one-touch closing position.
STEP 1
Continue holding the switch for a further 6 seconds after the win-
dow has closed.
Hold the power window switch in the one-touch opening position.
STEP 2
Continue holding the switch for a further 2 seconds after the win-
dow has opened completely.
Hold the power window switch in the one-touch closing position
STEP 3
once again. Continue holding the switch for a further 2 seconds
after the window has closed.
If you release the switch while the window is moving, start again from the
beginning. If the window continues to close but then re-open slightly even
after performing the above procedure correctly, have the vehicle inspected
by any authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
L/C150_OM_OM60J78E_(EE)
1-4. Opening and closing the windows and moon roof
1
139