Measurement And Correction Of Umbalance; Placing The Wheel On The Wheel Balancer; How To Compensate Umbalance Of Flanges Using Afc Function - Fasep B350.G3 User Manual

Fasep 2000 srl
Balatron B350.G3
5

MEASUREMENT AND CORRECTION OF UMBALANCE

5.1

Placing the wheel on the wheel balancer

5.1.1 Select the cone or flange suitable for the wheel to be balanced.
NOTE: the operation of centering and tightening of the wheel on the flanges is of basic importance for correct
balancing. Good results depend on proper performance of these procedures.
Clean accurately all cones, shaft and adappter surface before placing the wheel on the wheel balancer.
!
CAUTION:
5.2

How to compensate umbalance of flanges using AFC function

NOTE: This operation allows to put compensate unbalance of flange and other accessories.
5.2.1 Lock the required flange on the shaft without the wheel.
HOW TO TURN ON AFC FUNCTION
Always make sure flanges are correctly locked on the motor shaft and wheel is correctly locked on
the flange being used.
The ZERO led blinks.
The ZERO led is on.
HOW TO TURN OFF AFC FUNCTION
5-1
10 September 2012
Remove the flange.
The ZERO led switch off.
Rev. 1.1