Measurement And Correction Of Umbalance; Placing The Wheel Rim On The Wheel Balancer; Input Of Rim Dimensions (External Measuring System Version) - Fasep VIDEOTRONIC V688.G3 User Manual

Fasep 2000 srl
Videotronic V688.G3: User's Manual
7

MEASUREMENT AND CORRECTION OF UMBALANCE

7.1

Placing the wheel rim on the wheel balancer

7.1.1 Select the cone or flange suitable for the wheel to be balanced. Specific mounting instructions are delivered with each
flange

NOTE: the operation of centering and tightening of the wheel on the flanges is of basic importance for correct
balancing. Good results depend on proper performance of these procedures.
To accurately clean up the superficial ones of connection before whichever operation.
!
CAUTION:
7.2

Input of Rim Dimensions (external measuring system version)

for V65x, V64x, V55x-D (automatic input of all data)

NOTE: AUTOSELECT function admit to choose automatic selection of balancing system (Dynamic, ALU-S1, ALU-S2)
Always make sure flanges are correctly locked on the motor shaft and wheel is correctly locked on
the flange being used.
MAIN MENU
Insert the distance (fig.56).
Insert the width (fig.57).
Fig. 56: Distance
Fig. 57: Width
3-7
Rev. 1.0
15 July 2019