Measurement And Correction Of Umbalance; Placing The Wheel On The Wheel Balancer - Fasep BALATRON B150 User Manual

Fasep 2000 srl
Balatron B150: User's Manual
5

MEASUREMENT AND CORRECTION OF UMBALANCE

5.1

Placing the wheel on the wheel balancer

5.1.1 Select the cone or flange suitable for the wheel to be balanced.

NOTE: the operation of centering and tightening of the wheel on the flanges is of basic importance for correct
balancing. Good results depend on proper performance of these procedures.
Clean accurately all cones, shaft and adappter surface before placing the wheel on the wheel balancer.
!
CAUTION:
5.1.2 Lower the balancer through lift handle
5.1.3 Mount the flange
5.1.4 Near the wheel balancer to the wheel
5.1.5 Mount the wheel and the mating flange on the shaft
5.1.6 Lock the wheel on the shaft through locking handle
5.1.7 Lift the balancer through lift handle

NOTE: First of to proceed at the measure of the umbalance report the unit in position completely higher.
Always make sure flanges are correctly locked on the motor shaft and wheel is correctly locked
on the flange being used.
5-1
Rev. 1.0
07 June 2016