Table of Contents
Advertisement
Fasep 2000 srl
Balatron B350.G3
8
SPECIAL FUNCTIONS MENU
8.1
Enter in the special functions menu
Switch on the wheel balancer and press <SET> before SOF X.XX will disappear.
The possible functions are:
CAL
CAL tSt
CAL rod
SEn Sor
StA tiS
USr Set
tEc Set
Ser nuM
Act Cod
8.2
Diagnostic sensors menu
Switch on the wheel balancer and press <SET> before SOF X.XX will disappear. Select Sen Sor and press <SET>
to enter in the diagnostic sensors menu.
The possible functions are:
rPM
Balancing speed
dIS
Value of distance sensor
dIA
Value of diameter sensor
tO
Encoder is in the zero position
PoS
Angle of position sensor(from 0 to 255)
PS1
Voltage of PS1
PS2
Voltage of PS2
Cou
Safety cover is open or closed
8.3
Statistic menu
Switch on the wheel balancer and press <SET> before SOF X.XX will disappear. Select Sta tis and press <SET>
to enter in the statistic menu.
The possible functions are:
tOt
SUC
da 11 a 17
CAL
8.4
User Setup
Switch on the wheel balancer and press <SET> before SOF X.XX will disappear. Select USa SET and press <SET>
to enter in the user setup menu.
The possible functions are:
ScA LE Set 1 or 5 grams step (0.05/0.25 onces)
Cut oFF
Uni Out
Uni Umb
Fin AL
biP
EME StP
Cou Er
rod
rES Et Load Factory Setup
Calibration of wheel balancer
Control of the calibration of electronic sensors
Calibration of electronic input sensors
Diagnostic of sensors
Statistic about the use of machine
User setup
Technical Setup
Serial number
Inserting Activation Codes
Total number of spin
Percent of runs with a good result
Percent of wheels with the indicated diameter
Number of calibrations
Set minimum weight to be displayed
Unit of measure for the width (0=inch, 1=millimeters)
Unit of measure for the weight (0= grams, 1=once)
Display of final (0 = normal, 1 = blink, 2= Go OD).
Acustic signal (ON or OFF)
Motor brakes In case of emergency stop (On or OFF) (OFF: motor power is cut)
On = the motor start only if the safety cover is closed;OFF = safety cover is not installed; Aut =
closing of safety cover the motor starts automatically.
Enable/Disable automatic input system
9-1
Rev. 1.1
10 September 2012
Advertisement
Table of Contents
