Advertisement
IMPORTING PROGRAMS
COPYING PROGRAMS
FROM USB FLASH DRIVE.
PLEASE WAIT...
The programs are copied from the USB drive.
The instrument beeps during transfer.
When import has completed, press STOP to exit the utility. Remove the USB drive from the port.
When the programs are imported, the first program (ThinPrep protocol) is ignored and all remaining
programs (2-15) in the stainer memory are overwritten.
Password Implementation
Password utility allows the user to set or change the password.
The Password menu allows you to set and change a 4-digit Password for the system. The system is
shipped with no password set. A password of 0000 implies that the password use is deactivated.
To set a password, select the PASSWORD selection in Utility menu and enter the new password. The
system prompts you to enter it again. If the numbers don't match, an error message is displayed. If
the two numbers are the same, the new password will be saved.
It must then be entered correctly whenever the operator attempts to PROGRAM, or REVIEW a
program or to enter the UTILITY mode. For operator's convenience, once the password entry has
been entered correctly, PROGRAM, REVIEW and UTILITY menus are accessible for a period of 5
minutes without re-entering the password. For example, this allows the operator to review more
than one program without re-entering the password over and over again.
page 36
ENTER NEW PASSWORD:
0000
USE THE NUMBER KEYS,
THEN PRESS ENTER.
™
Compass
Stainer Operator's Manual
SUCCESS!
PRESS STOP TO EXIT.
File import complete. Press STOP to
exit.
Advertisement
