Advertisement
Select Program #1
RUN PROGRAM #: 1
TP_95%_ALC
REMOVE BATH COVERS!
ENTER: CONTINUE
Pre-loaded program for use with
ThinPrep Imaging
Once a desired program number is entered (program number followed by the ENTER key), the
software will check if the selected program exists in the memory. If the program exists in the memory,
the system will start the execution of the program once the user presses ENTER.
The transport mechanism is initialized first and "MOVING THE RACK..." message is displayed. Once
the rack is at a station, the run time status is displayed as follows:
page 20
ENTER PROGRAM #: 0
ENTER: ACCEPT NUMBER
User-configured stain program
™
Compass
Stainer Operator's Manual
Select Program #2
(for example)
RUN PROGRAM #: 2
REMOVE BATH COVERS!
ENTER: CONTINUE
Advertisement
