Fixing The Inverter; Other Precautions - Sungrow SG3125HV-20 System Manual

5 Mechanical Installation
N N o o
D

5.3.4 Fixing the Inverter

If the foundation is constructed as the above plan, the inverter needs to be hoisted to
the desired location and welded.
If the foundation is not constructed as the above plan, it is necessary to fix the fixing
point at the bottom of the inverter (shown as A below) with the existing operating
platform using L mounting parts.
The steps to fixing the L mounting parts is shown in the following figure.

5.3.5 Other Precautions

After fixing, the inverter should be fully welded with the pre-embedded channel steel.
A drainage system should be designed on the installation site to prevent the
inverter from being immersed in water during heavy rainfalls.
Do not plant any trees near the installation site to prevent the inverter from
being damaged by tree leaves or stems.
28
N N a a m m e e
Embedded 30#-c steel channel
System Manual