Advertisement
Figure 7. Media Installed - MEZZO Shown
MEDIA ALLOWED
ON PILOT SHIELD
Figure 8. Pilot Shield Media installation.
Hearth & Home Technologies • MEZZO/CRAVE/PRIMO Media Installation Instructions • 2300-945 Rev. N • 7/19
NO MEDIA
ALLOWED
APPROX. 1 IN.
SQUARE
Fogging Option
(MEDIA-FOG "Teco-Sil" Only)
7. If desired, the media can be fogged using high tem-
perature black paint (Hearth & Home Technologies
part number TUP-GBK-12).
tips. Prior to painting, take precautions to prevent any
overspray from reaching the pilot assembly.
• Apply paint with the LED lights turned on. This will help
you avoid over fogging or under fogging.
• Ensure firebox interior and logs (if installed) are covered
to prevent overspray.
• Reduce the lighting in the room while applying the paint.
• Fog the media to the desired look.
• Allow the paint to dry/cure a minimum of 15 minutes.
NOTE: MEDIA-FOG-60 is not approved for use with
PRIMO60/PRIMO60ST Propane appliances. Sooting could
occur.
Figure 9. Fogging the Media
8. Place the glass frame assembly back on the appliance
according to the instructions provided in the appliance
installation manual. Assure that there is no media be-
tween the glass and the firebox. Media in this area will
prevent the glass gasket from sealing.
WARNING! Risk of Asphyxiation! Install glass assem-
bly with care. Gasket MUST be sealed. Remove all me-
dia between glass and firebox.
MEZZO/CRAVE: Proceed to Step 9.
PRIMO: Proceed to Step 10.
See below for fogging
3
Advertisement
