Installation - ETC Echo Dual Tech Wall-mount Occupancy Sensor Installation Manual

ETC Installation Guide
Dual Tech Wall-mount Occupancy Sensor

Installation

Note:
725 and local jurisdiction requirements.
The wall-mount sensor is provided with a mounting bracket with pre-routed
wires that can be mounted to a back box. Follow the detailed instructions for
installation.
1. Pull the Belden 8471 (or equivalent) and one 2.5 mm
ground wire to the mounting location (back box or surface mounted
back box) and strip each wire 11 mm (7/16 in).
2. Connect the EchoConnect pigtail wires from the mounting bracket to
the installed wall wires.
a. Connect the data- (typically black) EchoConnect wire from
b. Repeat the above steps for the data+ (typically white)
3. Orient the mounting plate to the back box with the directional arrows
in the upright position and secure it in place using the screws
provided.
Dual Tech Wall-mount Occupancy Sensor
NEC Class 2 product to be wired in accordance to NEC Article
mounting bracket to the incoming data- (typically black) wire
using a WAGO wire termination connector (provided).
EchoConnect wire and for the ESD ground wire, using a new
WAGO connector for each termination type.
Page 4 of 12
2
(14 AWG)
ETC