ETC Echo Dual Tech Wall-mount Occupancy Sensor Installation Manual page 5

ETC Installation Guide
Dual Tech Wall-mount Occupancy Sensor
4. Install the wall plate to the
mounting plate.
a. Align the top of the wall
b. Hook the top of the wall
c. Swing the wall plate down,
d. If the wall plate does not fully attach, wiggle the bottom of the
5. Attach the sensor
head.
a. Slide the
b. Route the
c. Loosen the set
d. Slide the sensor onto the ball socket, and then tighten the set
6. Connect the three-position connector to the receptacle on the sensor
electronics.
Dual Tech Wall-mount Occupancy Sensor
plate to the mounting plate,
angling the bottom slightly.
plate to the tabs located on
the mounting plate.
ensuring the neck of the
sensor extension and wires
feed through the opening,
until the magnets engage.
plate until all of the magnets are seated properly.
removable
cover off the
sensor head.
three-position
connector with
wiring pigtail
through the
sensor head.
screw on the
sensor
retaining ring.
screw until secure.
c
b
a
Page 5 of 12
d
ETC