ETC Echo Dual Tech Wall-mount Occupancy Sensor Installation Manual page 10

ETC Installation Guide
Dual Tech Wall-mount Occupancy Sensor
Walk Test
The sensor offers a Walk Test mode, which shortens the vacancy timer to ten
seconds and allows for simple and quick verification of the sensor's coverage
and range in the installed space.
1. Prepare the site for configuration.
a. Make certain the sensor and lighting loads are powered and
b. You will need direct access to the sensor in order to place it into
2. Press the [Walk Test] button on the bottom of the sensor to enable
the Walk Test feature. A green LED will flash, indicating Walk Test is
enabled and the vacancy timer will be shortened to ten seconds.
3. Move throughout the space including corners and areas that may be
obscured from line of sight to the sensor. Each time the sensor detects
movement, the lens illuminates red. If acoustic detection is enabled,
any sound detected will illuminate the lens green.
4. As needed, adjust the angle of the sensor head to obtain optimal
detection in the space.
5. Walk Test mode automatically exits and the sensor returns to normal
operation after five minutes. You can also manually terminate by
pressing the [Walk Test] button again.
Dual Tech Wall-mount Occupancy Sensor
connected for control by the Echo control system.
Walk Test mode.
[Walk Test]
button
Page 10 of 12 ETC