Trouble Shooting - Webb WER40HPSFX Original Instructions Manual

INSTRUCTION MANUAL

TROUBLE SHOOTING

PROBLEM POSSIBLE CAUSE
1. OPC/Brake lever not engaged
2. Spark plug cap not connected to
spark plug.
Engine fails 3. Fuel tank empty
to start. 4. Fuel is over 30 days old and stale.
5. Block fuel pipe
6. Faulty spark plug
7. Engine flooded
1. Spark plug cap loose.
2. Blocked fuel line
3. Stale fuel
Engine runs
4. Vent in Petrol cap blocked
erratic
5. Water or dirt in fuel system
6. Dirty air filter
7. Carburettor operating incorrectly.
1. Engine oil low
Engine
2. Air flow restricted
overheats
3. Carburettor operating incorrectly.
Engine
hesitation 1. Spark plug gap incorrect.
at high speed
1. Spark plug fouled, faulty or gap
incorrect.
Engine idles
2. Carburettor not functioning
erratically
correctly.
3. Dirty air filter.
Uneven cut 1. Dull blade
SOLUTION
1. Engage OPC/Brake lever
2. Connect spark plug cap to spark plug.
3. Fill with clean, fresh fuel
4. Carburettor gummed up, take to approved
service dealer for non-warranty repair.
5. Clean fuel pipe & filter
6. Clean, adjust or replace spark plug.
7. Remove spark plug, dry off and reseat.
1. Connect cap to spark plug and ensure
tight.
2. Clean fuel pipe and filter
3. Remove fuel and use fresh fuel.
4. Clean vent
5. Drain fuel tank, refill with fresh fuel
6. Clean air filter
7. Have carburettor inspected by approved
service dealer and adjusted.
1. Fill engine with correct oil. Ensure dipstick
is checked to ensure oil is within minimum
& maximum levels.
2. Remove blower housing and clean.
3. Have carburettor inspected by approved
service dealer and adjusted.
1. Adjust spark plug gap to between 0.6-
0.8mm
1. Adjust spark plug gap to between 0.6-
0.8mm
2. Have carburettor inspected by approved
service dealer and adjusted.
3. Clean air filter.
1. Have blade sharpened or replaced.