Bras B-Cube HOT Operator's Manual page 20

EN GLIS H
B-Cube HOT
7. 5. 3 WASHING
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source.
IMPORTANT
Do not attempt to wash any machine
components in a dishwasher.
1
Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-140 °F)
potable water and dishwashing detergent. Do not
use abrasive detergent.
Important: if present, follow label directions, as
too strong a solution can cause parts damage,
while too mild a solution will not provide
adequate cleaning.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastic parts.
2
Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in the
cleaning solution.
ATTENTION
When cleaning the machine, dump it, do
not allow excessive amounts of water
around the electrically
components of the unit. Electrical shock or
damage to the machine may result.
3
In the same manner clean the evaporator
cylinder(s) using a soft bristle brush.
4
Clean the dispensing spout with the provided
cleaning brush supplied. (vedere figure 14)
5
Rinse all cleaned parts with cool clean water.
7. 5. 4 SANITIZING
Sanitizing should be performed immediately
prior to starting the machine. Do not allow the
unit to sit for extended periods of time after
sanitization.
Sanitization must be performed whenever the
distributor is put back into operation with a
new product.
1
Wash hands with a suitable antibacterial
soap.
2
Prepare at least two gallons of a warm (45-
60 °C 120-140 °F) sanitizing solution (100 PPM
available chlorine concentration or 1 spoon of
sodium hypoclorite diluted with 2 litres of water)
according to your local Health Codes and
manufacturer's specifications.
operated
3
Place the parts in the sanitizing solution for
five minutes.
4
Place the sanitized parts on a clean dry
surface to air dry.
5
Wipe clean all exterior surfaces of the unit.
Do not use abrasive cleaner.
20
figure 14