Advertisement
SAFETY PRECAUTIONS
Failure to comply with these precautions may cause loss of load, damage to,
or failure of the jack, resulting serious personal injury, or damage to property.
✘
NEVER exceed the jack's capacity of 1000kg, and use it ONLY for the purpose for
which it is intended.
IMPORTANT: If the load capacity decal becomes worn or illegible, contact Clarke
International Spare Parts Department, on 0208 988 7400 for replacement.
✘
NEVER use the jack if it has been subjected to an abnormal load or shock. It should be
removed from service immediately and fully inspected by qualified personnel, and
passed as serviceable, before being used again.
✘
NEVER stand under the load.
✘
NEVER rely upon the Hydraulic Ram (item 1), to support the load . When working on
the transmission.
✘
NEVER transport a load in the elevated position
✔
ALWAYS use the Jack on a solid, flat, level surface only.
✔
ALWAYS wear appropriate safety equipment, such as protective footwear, when using
this jack.
✔
ALWAYS inspect the jack before use to ensure it is in good condition, and replace any
damaged or worn parts.
✔
ALWAYS use spare parts supplied by Clarke International. Using non-standard parts
could be extremely dangerous.
✔
ALWAYS lower the load as much as possible before moving the jack. NEVER transport
loads in an elevated position.
✔
ALWAYS ensure that the centre of gravity of the load is centred about the cradle before
taking the full weight.
✔
ENSURE that the jack is properly maintained, and lubricated at all times, and that no
rust or other forms of corrosion is allowed to weaken any part of it.
✔
ENSURE the operator is skilled and trained in both operation and safety aspects.
WARNING
Advertisement
