Related Manuals for Clarke CTJ1800AB
Summary of Contents for Clarke CTJ1800AB
- Page 1 1.8 TONNE ALUMINIUM RACING JACK MODEL NO: CTJ1800AB PART NO: 7623201 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0122...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE 1.8 Tonne aluminium racing jack. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
6. DO NOT make any modifications to this jack or adjust any valves. 7. DO NOT use the jack if an oil leak is apparent. Consult your CLARKE dealer. 8. DO NOT use to lift people and ensure that no-one is in the vehicle during lifting. -
Page 4: Unpacking And Assembly
UNPACKING AND ASSEMBLY ASSEMBLY 1. Insert the lower half of the jack handle into position as shown. • Make sure that the square bar inside the handle yoke engages with the hole in the jack handle. 2. Secure the handle by tightening the thumbscrew shown. -
Page 5: Operation
OPERATION POSITIONING Ensure the vehicle is chocked and stable and on firm level ground. 1. Turn the jack handle counterclockwise, to lower the lifting ram. 2. Position the jack so that the saddle is directly beneath the lifting point and that there are no obstacles to prevent a clean lift, also, make sure that all personnel are well away from the area, before raising the vehicle. -
Page 6: Maintenance
Store in a dry place, with the ram fully retracted. If stored for long periods, inspect at least once a year, clean and re-oil. For servicing, contact your CLARKE dealer or CLARKE International Service Department. BLEEDING THE HYDRAULIC SYSTEM 1. Put the jack on horizontal ground. - Page 7 • CLARKE Hydraulic oil is available from your local CLARKE dealer. NOTE: Do not touch the assembled handle when adding the hydraulic oil.
-
Page 8: Troubleshooting
7. Air in the hydraulic Bleed the system. See page 6. system If any of these remedies fail to restore your jack, consult your CLARKE dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 9: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 10: Component Parts - (General Assembly)
COMPONENT PARTS - (GENERAL ASSEMBLY) Description Description Saddle Pad Screw Saddle Screw Washer Saddle Screw Saddle Base Rear Caster Hinge Pin Rear Caster Base Circlip Washer Front Axle Spring Clip Side Plate Spring Front Wheel Bush Circlip Front Wheel Trunnion Arm Front Wheel Washer Hydraulic Unit Handle Sleeve... - Page 11 COMPONENT PARTS -(GENERAL ASSEMBLY) Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...