Page 1
1.8 TONNE ALUMINIUM RACING JACK MODEL NO: CTJ1800A PART NO: 7623200 OPERATION & MAINTENANCE INSTRUCTIONS LS1215...
Page 2
INTRODUCTION Thank you for purchasing this CLARKE 1.8 Tonne aluminium racing jack. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
9. Ensure that all personnel are well clear of a load being raised or lowered. 10. Do not use if an oil leak is apparent. Consult your Clarke dealer. 11. Consult the vehicle handbook to determine the correct lifting points.
BEFORE USE ASSEMBLY 1. Remove the transport clip. 2. Insert the lower half of the jack handle into position as shown. • Make sure that the square bar inside the handle yoke engages with the hole in the jack handle. 3.
OPERATION POSITIONING Ensure the vehicle is chocked and stable and on firm level ground. 1. Turn the jack handle counterclockwise, to lower the lifting ram. 2. Position the jack so that the saddle is directly beneath the lifting point and that there are no obstacles to prevent a clean lift, also, make sure that all personnel are well away from the area, before raising the vehicle.
Store in a dry place, with the ram fully retracted. If stored for long periods, inspect at least once a year, clean and re-oil. For servicing, contact your CLARKE dealer, or CLARKE International Service Department. BLEEDING THE HYDRAULIC SYSTEM 1. Put the jack on horizontal ground.
7. Air in the Beed the system. See page 6 hydraulic system If any of these remedies fail to restore your jack, consult your Clarke dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...