Page 1
1 TONNE TRANSMISSION JACK Model: CTJ100 Part No: 7612610 OPERATING & MAINTENANCE INSTRUCTIONS 0900...
Page 2
GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase.
NEVER exceed the jack’s capacity of 1000kg, and use it ONLY for the purpose for which it is intended. IMPORTANT: If the load capacity decal becomes worn or illegible, contact Clarke International Spare Parts Department, on 0208 988 7400 for replacement.
UNPACKING AND PREPARATION FOR USE The jack comes fully assembled. It is necessary only to remove the travel plug, fitted to the Ram, and replace it with the Vent Plug provided. Fig. 1 shows the Vent Plug fitted at ‘A’. Fig.
Turn the Pressure Valve knob anticlockwise and allow the table to lower completely. Unscew and remove the Vent Plug (A, Fig.1). If necessary, fill to just below the bottom of the Vent Plug orifice using Clarke Hydraulic oil (see your Clarke dealer), then replace the Vent Plug.