Related Manuals for Clarke CTJ1500QULP
Summary of Contents for Clarke CTJ1500QULP
- Page 1 1.5 TONNE GARAGE JACK MODEL NO: CTJ1500QULP PART NO: 7623075 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0220 - ISS -2...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE Garage Jack. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
1. Check the jack for damage before use and do not use if damaged. If in doubt, DO NOT use. Consult your local dealer. 2. ALWAYS use spare parts supplied by Clarke International. Using non- standard parts could be extremely dangerous. -
Page 4: Unpacking And Assembly
safety of the jack is maintained. 5. NEVER use the jack if it has been subjected to excess load (over 1.5 tonnes). The jack should be removed from service immediately and fully inspected by qualified personnel and passed as serviceable before further use. -
Page 5: Maintenance
5. Take care that no obstruction prevents a clean lift. Keep all personnel at a safe distance before lifting the vehicle. NOTE: The jack may move slightly during operation. It is important therefore, that the floor is clean and free from debris. -
Page 6: Checking The Oil Level
2. Remove the cover plate and the oil filler plug. • The oil should be almost level with the bottom of the oil filler hole. • Oil can be topped up using Clarke Hydraulic Oil (p/no 3050830 for 1 litre). -
Page 7: Troubleshooting
Purge the system as on p 5 Jack will not Return spring may be Return to your Clarke dealer for lower completely faulty repair If any of these remedies fail to restore your jack, consult your Clarke dealer DECLARATION OF CONFORMITY... -
Page 8: Component Parts - General Assembly
COMPONENT PARTS - GENERAL ASSEMBLY... - Page 9 COMPONENT PARTS - GENERAL ASSEMBLY Description No Description Circlip 20mm Yoke roller pin Washer 20mm Foot pedal Front wheel Screw M5x16 Chassis frame Release knob Circlip 25mm T-pump handle Nut M16 Hydraulic unit Washer M16 Return spring Screw M5x12 Link block Rear castor assembly Circlip 22mm Screw M12x 25...
- Page 10 COMPONENT PARTS - HYDRAULIC PARTS Description No Description Sealing ring High pressure piston housing Reservoir O-ring 10 x 2.65 # Sealing ring Retaining ring 15 x 10.6 x 1.25 O-ring 29x3.55 # High pressure piston Top nut Piston return pring HP piston dust cover Circlip 30mm Return spring seat...
- Page 11 COMPONENT PARTS - HYDRAULIC PARTS...