Subscribe to Our Youtube Channel
Related Manuals for Clarke CTJ3QLGB
Summary of Contents for Clarke CTJ3QLGB
- Page 1 3 TONNE TROLLEY JACK CTJ3QLGB MODEL NO: PART NO: 7621000 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS DL1021...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE Trolley Jack. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Precautions
9. DO NOT try to lift more then the rated load for the jack. 10. DO NOT use the jack if an oil leak is apparent. Consult your CLARKE dealer. 11. Consult the vehicle handbook to determine the correct lifting points. -
Page 4: Unpacking And Assembly
UNPACKING AND ASSEMBLY 1. Connect the two halves of the Operating Handle and secure with the locking pin. 2. Remove the packing/storage clip shown. NOTE: DO NOT dispose of packing/ storage clip, as this is needed for access to the oil plug, see page 7. -
Page 5: Safety Symbols
SAFETY SYMBOLS Always read Always wear manual fully protective before use. footwear Always chock Always lift from wheels the central jacking point (See vehicle manual for location) Never use a single Never support the axle stand and vehicle on 4 axle jack to support stands the vehicle... -
Page 6: Operation
OPERATION Before use, inspect the jack for oil leaks or any other sign of damage. Should any be apparent, have the jack repaired by a qualified technician. WARNING: NEVER WORK ON THE VEHICLE WHEN SUPPORTED ONLY BY A JACK. THIS IS HIGHLY DANGEROUS. THE VEHICLE SHOULD BE SUPPORTED ON AXLE STANDS OR SUITABLE SUPPORTS, BENEATH THE CORRECT JACKING/SUPPORT POINTS. -
Page 7: Maintenance
• Oil can be topped up using CLARKE Hydraulic Oil (p/n 3050830 1 litre). 4. Purge any air from the system and replace the oil plug. 5. Dispose of old/spilled oil appropriately and wipe up any spillage. -
Page 8: Troubleshooting
Too much oil in the Screw out the drain valve and drain hydraulic system. out the excess oil - See “Checking and Maintaining the Oil Level” section on page 7. If any of these remedies fail to restore your jack, consult your CLARKE dealer. -
Page 9: Declaration Of Conformity
DECLARATION OF CONFORMITY... -
Page 10: Component Parts - General Assembly
COMPONENT PARTS - GENERAL ASSEMBLY... - Page 11 COMPONENT PARTS - GENERAL ASSEMBLY Description No Description Saddle Handle Cover Lifting Arm Assembly Shoulder Bolt M18 x 66.5mm C-Clip Ø18mm Torsion Spring Right Frame Assembly Handle Socket Shaft for Front Wheel Handle Socket Screw M10 x 19mm Front Wheel Washer M8 Side-mount External Retaining Shaft for Spur Gear...
Need help?
Do you have a question about the CTJ3QLGB and is the answer not in the manual?
Questions and answers