Stryker Ultra Comfort SE 1703 Operation Manual page 15

A A p p p p l l y y i i n n g g V V e e l l c c r r o o ® t t o o t t h h e e 0 0 7 7 4 4 7 7 s s t t r r e e t t c c h h e e r r
W W A A R R N N I I N N G G - - Always apply the supplied Velcro to the 0747 stretcher to make sure that the mattress is secure. Non-use may
result in patient harm due to mattress movement.
• (1) Fowler (A) V V e e l l c c r r o o pile (0785-034-007)
N N o o t t e e - - This kit is to attach the mattress to the Model 0747 Transport Stretcher frame. If the V V e e l l c c r r o o pattern on the mattress
does not match the pattern on the frame, please follow these instructions.
T T o o o o l l s s r r e e q q u u i i r r e e d d
• Tape measure
P P r r o o c c e e d d u u r r e e
N N o o t t e e - - Remove the product from service before you perform this upgrade.
1. Raise the product to the highest height position.
2. Remove and save the mattress.
3. Push down on the brake pedal to apply the brake.
4. Wipe the surface with isopropyl alcohol (70% alcohol).
5. Allow the surface to dry for at least two minutes.
6. Remove the backing on the fowler V V e e l l c c r r o o (A) and apply the V V e e l l c c r r o o to the surface of the fowler (Figure 1).
7. Press on the center of the V V e e l l c c r r o o and all edges to secure to the surface.
8. Allow the adhesive to cure for at least one hour before you return the product to service.
N N o o t t e e - - For best results, allow the adhesive to cure for 24 hours before you return the product to service.
9. Repeat steps 1-8 to replace the V V e e l l c c r r o o (B) at the foot end (Figure 2).
1704-009-001 Rev F.0
• (2) V V e e l l c c r r o o pile (adhesive back) (B) (0785-034-005)
(5.1)
(9.0)
F F i i g g u u r r e e 1 1 – – A A p p p p l l y y V V e e l l c c r r o o t t o o t t h h e e f f o o w w l l e e r r
A
11 EN