Operation; Cleaning And Preserving Agent; Nozzles And Recoil Forces - Frank FEM 718 MSE-Z Operating Instructions Manual

5.

Operation

5.1 Cleaning agents
FRANK Cleaning agents
FRANKOCLEAN NER 0800
FRANKOCLEAN FZG 1070
FRANKOCLEAN FZG 1170
FRANKOCLEAN ALU 1020
FRANKOCLEAN LWB 1140
5.2 Nozzles and recoiling forces
The approved nozzle is adapted to the maximum flow rate, the admissible pump
pressure and to the direct connection of a high-pressure hose pipe DN 8 x 10 m.
The appropriate nozzle size is to be taken from the table below.
For long-distance pipings and/or longer hose pipes larger nozzles are to be used.
The nozzle size is to be chosen and laid down in such a manner that the working
pressure of the high-pressure stage (HD), indicated in section 2, is not exceeded.
Admissible
nozzles;
code number
0004
1504
2504*
4004
5004
6504
*Supplied nozzle for direct connection to a high-pressure hose DN 8 10 m without remote piping.
Only the following FRANK chemicals and possibly
certain other additional agents authhorized by the
manufacturer may be used, since material compatibility
can only be guaranteed for these cleaning agents.
Observe the instructions for use of these cleaning and
preserving agents. If necessary, wear protective glasses
and safety clothing.
When handling safety spray lance, the recoil should be taken into
account, and the fact that torque is produced by the recoil when
angled spray lances are in operation. This torque increases with the
length of the lance.
Jet shape Spray
angle
Full jet -
Flat jet 15°
Flat jet 25°
Flat jet 40°
Flat jet 50°
Flat jet 65°
- 10 -
FRANKOCLEAN LMI 0480
FRANKOCLEAN WAX 0710
FRANKOCLEAN DEF 1040
FRANKOCLEAN AKO 1000
FRANKOCLEAN HRB 1150
Flow rate
l/min.
11,5
Pump
pressure
bar
180
Recoil
N
32 N