CHERUBINI Skipper LCD Instructions Manual page 12

HOW TO PROCEED WITH CHERUBINI MOTORS GARDA RX AND CONTROL UNITS
COD. A510015 – A510017 – A510022:
The programming of the remote controls for the above mentioned products requires a certain
sequence in the use of the keys. Please keep the following functions of the keys in mind:
Skipper Series
(not-LCD)
A
B
C
STORING OF THE FIRST REMOTE CONTROL
ATTENTION! This Programming is only necessary when the receiver (motor or control unit)
is installed for the first time, that is to say, when it is not yet connected to any remote
control. Otherwise, see: "STORING OF OTHER REMOTE CONTROLS".
- Make sure that the receiver (motor or control unit) is supplied with energy.
- Path: Main menu / Commands / Devices / CREATED DEVICE.
- Use the keys in the following sequence:
LCD1= First device to be stored on Skipper LCD
LCD1
A
+ B
- After storing, use the UP / DOWN / STOP keys to check whether the motor is working correctly.
- After checking, press BACK or forward.
STORING OF OTHER REMOTE CONTROLS
The procedure remains the same in all 3 cases. Only the order in which the remote controls
are used changes. Please refer to the following scheme in order to find the procedure which
meets your requirements:
To add:
Skipper LCD
Another Cherubini
remote control*
Skipper LCD
*Remote control of the Skipper series (not LCD) or Giro series.
SEL
SEL
A
B
C
B
To another device
created using:
Another Cherubini
remote control*
Skipper LCD
(another) Skipper LCD
Giro Series
A
B
C
Tn/Cn
Skipper/Giro
A+B; B
LCDn
Skipper LCD
A+B; B
LCDn
Skipper LCD
A+B; B
31
LCD remote control
B
2sec
PROCEDURE:
LCDx
Skipper LCD
B (2 sec)
Tx/Cx
Skipper/Giro
B (2 sec)
LCDx
Skipper LCD
B (2 sec)
A
B
C
4
5
6