Figure 41. Installing the drive cage
Next steps
1.
Install the drive
backplane.
2.
Install the
drives.
3. Follow the procedure listed in
Battery backup unit
Removing the battery backup unit
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
drives.
4. Disconnect the battery backup unit (BBU) cable from the system board.
5. Disconnect the backplane cables.
6.
Remove the drive
cage.
7.
Remove the drive
backplane.
Steps
1. Press the latch on the side of the drive cage to release the BBU module.
2. Holding the BBU module by the edges, slide the BBU module out of the system.
38
Installing and removing system components
After working inside your sled
Safety
Instructions.
Before working inside your sled
on page 17.
on page 17.