Figure 96. Installing the optical drive
Next steps
1. If removed,
install the front
2. Connect the power cable and the data cable to the optical drive.
NOTE:
Route the cables properly to prevent them from being pinched or crimped.
3. Follow the procedure that is listed in
Optional tape backup unit
This is a service technician replaceable part only.
Removing the tape backup unit blank
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. If installed,
remove the front
Steps
Push the protrusion at the rear of the tape backup unit blank and slide it towards the front of the system.
bezel.
After working inside your
Safety
instructions.
Before working inside your
bezel.
system.
system.
Installing and removing system components
101