1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Place the drive cage into the sled, aligning with the screw holes on the sled.
2. Using the Phillips #1 screwdriver, secure the drive cage with screws.
Figure 44. Installing the drive cage
Next steps
1.
Install the drive
backplane.
2. Connect the cables to the drive backplane.
3.
Install the removed
drives.
4.
Install the
PEM.
5. Follow the procedure listed in the
Battery backup unit
Removing the battery backup unit module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
PEM.
4. Disconnect the two cables from the battery backup unit (BBU) to the connectors on the system board.
44
Installing and removing sled components
Safety instructions
Before working inside your sled
After working inside your sled
Safety instructions
Before working inside your sled
section.
section.
section.
section.
section.