Figure 65. Installing the Jumbo PERC card
Next steps
1. Connect the cable on the Jumbo PERC card.
2. Follow the procedure listed in the
Optional Internal dual SD module
The IDSDM module combines the IDSDM features into a single module.
NOTE:
The write-protect switch is on the IDSDM module.
Removing the IDSDM card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Locate the IDSDM card connector on the system board. To locate IDSDM connector, see the
connectors
section.
2. Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD card (IDSDM) to the system
board.
CAUTION:
To prevent damage to the IDSDM card, you must not tilt the card while lifting it from the system
board.
3. Lift the release tab that secures the IDSDM to the system board.
4. Holding both ends of the IDSDM, lift the IDSDM out of the BOSS connector on the system board.
After working inside your
Safety
Instructions.
Before working inside the
sled.
sled.
Installing and removing system components
system board jumpers and
67