Table of Contents
Advertisement
Figure 80. Removing the system battery
3. To install a new system battery:
a. Hold the battery with the + sign facing the positive side of the battery connector.
b. Insert the battery down into the connector and push the positive side of the battery until the battery snaps into place.
Figure 81. Installing the system battery
Next steps
1. Follow the procedure listed in
2. Enter the System Setup to confirm that the battery is operating properly.
3. Enter the correct time and date in the System Setup's Time and Date fields.
4. Exit the System Setup.
5. To test the newly installed battery, remove the system from the enclosure, for at least an hour.
6. Reinstall the system into the enclosure, after an hour.
7. Enter the System Setup and if the time and date are still incorrect, see
82
Installing and removing system components
After working inside your sled
on page 17.
Getting
help.
Advertisement
Table of Contents
