Table of Contents
Advertisement
Steps
1. Press the blue release button on the sled to release the sled handle.
2. Holding the sled handle, slide the sled out of the enclosure.
NOTE:
Support the system with both hands while sliding it out of the enclosure.
NOTE:
Removing the sled with the enclosure powered on is supported if you shut down the sled before removal.
Figure 12. Removing the sled from enclosure
3. Install the I/O connector cover on the sled.
CAUTION:
To protect the I/O connector pins, install the I/O connector cover every time a sled is removed
from the enclosure.
Figure 13. Installing the I/O connector cover on sled
18
Installing and removing system components
Advertisement
Table of Contents
