Table of Contents
Advertisement
CAUTION:
If either the system board or iDRAC card fails, it is required to replace both system board and iDRAC
card at the same time.
Steps
1. Align the iDRAC card with the guide pin on the system board.
2. Lower the iDRAC card into place until the iDRAC connector is fully seated.
3. Press the blue touch points till the iDRAC card is firmly seated on the system board connector.
Figure 60. Installing the iDRAC card
Figure 61. Installing a vFlash card
Next steps
1. Follow the procedure listed in
PERC card
Your system includes dedicated slots on the system board for PERC cards.
After working inside your sled
on page 17.
Installing and removing system components
63
Advertisement
Table of Contents
