VERDER VERDERAIR VA-EH50 Repair Parts page 4

Warnings
PRESSURIZED EQUIPMENT PRESSURIZED PRESSURIZED
Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin
and cause serious injury.
• Follow the Pressure
cleaning, checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check fluid lines, tubes, and couplings daily. Replace worn or damaged parts immediately.
EQUIPMENT MISUSE EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request Safety Data Sheet (SDS) from distributor or retailer.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route fluid lines and cables away from traffic areas, sharp edges, moving parts, and hot
surfaces.
• Do not kink or over bend fluid lines or use fluid lines to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
PRESSURIZED ALUMINUM
PRESSURIZED PRESSURIZED
Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious
chemical reaction and equipment rupture. Failure to follow this warning can result in death,
serious injury, or property damage.
• Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon
solvents or fluids containing such solvents.
• Do not use chlorine bleach.
• Many other fluids may contain chemicals that can react with aluminum. Contact your material
supplier for compatibility.
4
WARNING
EQUIPMENT EQUIPMENT HAZARD HAZARD HAZARD
Pressure Relief Pressure Relief Procedure Relief Procedure when you stop spraying/dispensing and before Procedure
MISUSE HAZARD MISUSE HAZARD HAZARD
Technical Data Technical
ALUMINUM PARTS PARTS HAZARD
ALUMINUM PARTS
Data in all equipment manuals. Data
Pressure Relief Pressure Relief Procedure Relief Procedure when equipment is not in use. Procedure
HAZARD
HAZARD
Technical Data Technical Data Data
859.0773