Visual Inspection; Drying And Storage - Pari 041G0500 Instructions For Use Manual

In boiling water
• Place all the individual parts in boiling water for at least
5 minutes.
Use a clean pot and fresh drinking water.
If your water is very hard ...
If your water is very hard, scale may be deposited on the
plastic parts as a milky coating. This can be prevented by
using softened water.
Plastic will melt ...
NOTICE
Plastic will melt if it comes into contact with the hot base of the
pot. Therefore, make sure there is plenty of water in the pot. This
way you will avoid damaging the components.
Using a standard thermal disinfector for baby bottles
(not a microwave oven)
Disinfection must last at least 15 minutes. Regarding disinfec-
tion and the quantity of water required for this, it is essential to
follow the instructions for use of the disinfector you are using.
Always check carefully that it is clean and fully functional.

4.4 Visual inspection

Inspect all product components after each cleaning/disinfection.
Replace any broken, misshapen or seriously discoloured parts.

4.5 Drying and storage

• You can remove excess water more quickly by shaking all parts.
• Place all parts on a dry, clean and absorbent surface and let
them dry completely.
• When drying, between applications, and in particular during
long breaks, wrap the PARI Filter/Valve Set in a clean, lint-free
cloth (e.g. a tea-towel) and keep in a dry, dust-free environment.
• Store the PARI Filter/Valve Set safely out of continuous direct
sunlight.
- 33 -
en