Visual Inspection - Pari SOLE N Series Manual

In boiling water
• Place all the individual parts in boiling water for at least
5 minutes.
Use a clean pot and fresh water with reduced calcium
content, if possible.
Plastic will melt if it comes into contact with the hot base of
the pot. Therefore, make sure there is plenty of water in the
pot. This way you will avoid damaging the components.
• You can remove excess water more quickly by shaking all
parts.
Using a standard thermal disinfector for baby
bottles (not a microwave oven)
For effective disinfection, use a disinfector with a runtime of at
least 6 minutes. Regarding disinfection, the duration of the dis-
infection procedure and the quantity of water required for this,
follow the instructions for use of the disinfector you are using.
CAUTION
Inadequate disinfection encourages the growth of bacteria
and thus increases the risk of infection. Thorough disinfec-
tion has not been completed until the disinfector automatic-
ally switches itself off, or the minimum disinfection time spe-
cified in the instructions for use of the disinfector has
elapsed. Therefore, do not switch the device off prematurely.
Also make sure that the disinfector is kept clean and regu-
larly check that it is in good working order.

4.5 Visual inspection

Inspect all product components after each cleaning and disin-
fection. Replace any broken, misshapen or seriously
discoloured parts.
– 44 –