Settings - NOVOTEST UD3701 Operation Manual

For setting the gate position user has to click by finger the selected gate and move it to necessary
place of A-scan (Figure 2.12).
а) the gate is out of signal
Displayed values of testing parameters could be moved to any new place of A-scan, if this
function is set by the device for the particular parameter (Figure 2.13).
а) parameter in start position

2.4.3 Settings

After selection in Main menu «SETTINGS» mode (Figure 2.14) the device is ready for setting the
follow parameters:
1. Screen:
 Brightness. Setting of the screen brightness. The higher is brightness the lower is
operating time of the scanner battery;
 Bright. Setting the time of automatic brightness reducing;
 Aero. Turn on/off edge visibility of interface elements. It has influence on visibility of
menu some other elements;
 Degree of transparency. Setting degree of transparency for parameter panel;
 Antialiasing. Turn on/off antialiasing. The mode makes shifts visual better but makes
operating slower;
 Palette. Selection and setting the color palette of interface. User can set colors of the
screen by himself;
 Fly. Allows move parameter values on A-scan. Parameter value could be moved to
any place of A-scan;
Figure 2.12 – Relocation of the gate
Figure 2.13 – Relocation of the parameter value
Ultrasonic Flaw Detector NOVOTEST UD3701
b) signal crosses the gate
b) parameter after relocation
Operation manual
Page 32